Section I. REPAIR PARTS; SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC
EQUIPMENT; AND SUPPORT EQUIPMENT
COMMON TOOLS AND EQUIPMENT.
For authorized common tools and equipment refer to the Modified Table of Organization and Equipment
(MTOE), CTA 50-970 or CTA 8-100, as applicable to your unit.
The basic tool kit is: Tool Kit, General Mechanics: Automotive SC 5180-90-N26.
SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT.
Refer to Appendix B, Section III, of the Maintenance Allocation Chart (MAC) for a list of tool kits authorized for the Heater.
Refer to Appendix G, Repair Parts and Special Tools List (RPSTL), for a list of special tools required for maintenance of
Repair parts are listed and illustrated in Appendix G of this manual.
Section II. SERVICE UPON RECEIPT
PACKING AND UNPACKING.
Upon receipt of a new Heater, the receiving organization must see if it has been properly prepared for service and is in
good condition. Inspect all assemblies, subassemblies, and accessories to be sure they are in proper working order.
Secure, clean, and correctly adjust and/or lubricate as needed, Chapters 2 and 3. Check all tools and equipment
(Appendix C and Appendix D) to be sure every item is there in good condition, clean, and properly stowed.
LOOSE PARTS INSTALLATION.
The Heater comes fully assembled. Perform regularly scheduled PMCS upon receipt.
If Heater has been towed to the using organization, most or all of the following
work should have been done.
When Heater is received, inspect all items for damage that may have occurred during shipping and unloading operations.
Pay close attention to any loose or missing nuts, bolts, screws, drain plugs, assemblies, subassemblies, or components
that may be easily lost or broken in transit. Check Components of End Items (COEI) and Basic Issue Items (BII),
Appendix C, and Additional Authorized List (AAL), Appendix D, to make sure all items are accounted for and are in good
condition. Carefully list all discrepancies.