(2) Remove screw from the exhaust pipe clamp
and remove the exhaust pipe from the engine.
Refer to TM 5-2805-256-14 for removal, inspection
b. Inspection. Inspect the exhaust tube and gasket
and reinstallation of engine air cleaner. Reference
for any breaks, cracks, or damaged threads.
includes instructions on how to replace filter.
c. Installation. Reverse the procedure in a. above.
Refer also to TM 5-2805-256-14 for removal, in-
spection and reinstallation of the engine fuel filter.
Reference includes instructions on cleaning and/or
replacing sediment bowl.
CAUTION
When removing or installing fuel lines
and fittings, do not allow lines to
become kinked or flattened.
a. Removal. Unscrew the coupling nut on the line
and hose assemblies at the points shown in figure 4-2
and remove the line and hose assemblies from the
heater.
b. Cleaning. Clean the line and hose assemblies in
approved cleaning solvent and blow through it with
compressed air to remove any foreign matter.
c. Inspection. Inspect the line and hose assemblies
for dents and possible breaks or holes and the
coupling nuts for distortion and damaged or stripped
threads. If they are defective, install serviceable
ones.
d. Installation. Reverse the procedure in o. above.
Refer to TM 5-2805-256-14 for removal, inspection
and reinstallation of engine air cleaner hose.
4-21 Rope Starter
The rope starter is furnished loose and therefore
does not require removal and replacement in-
a. Removal and Disassembly.
(1) Remove 2 screws from the exhaust pipe
structions. Inspection should be for cuts or fraying
and replacement should be made if damaged.
flange at the engine.