CHAPTER 5
DIRECT SUPPORT MAINTENANCE INSTRUCTIONS
Section I. REPAIR PARTS, SPECIAL TOOLS AND EQUIPMENT
5-1. Tools and Equipment
There are no tools or equipment authorized other than those listed in appendix C for direct support maintenance
personnel.
5-2. Special Tools and Equipment
There are no special tools or equipment required by maintenance personnel to maintain the space heater.
5-3. Maintenance Repair Parts
Repair parts and equipment covering direct support maintenance are listed and illustrated in the repair parts and special
Section II. TROUBLESHOOTING
Refer to paragraphs 3-4 and 4-11 for troubleshooting information relative to this equipment.
Section III. GENERAL MAINTENANCE
The maintenance to be performed by direct support maintenance personnel on this equipment is limited repair of the fuel
lines and fittings and repair of the roof jack assembly. Repair is accomplished by replacement.
Section IV. REMOVAL AND INSTALLATION OF MAJOR COMPONENTS
5-4. Heater Base
b. Inspect heater base for elongated bolt holes, cracked corner welds, rust, peeling paint, dents and distortion,
leveling legs for stripped or damaged threads.
c. Repair heater base or replace if necessary. Install in the reverse order of removal.
5-1