APPENDIX C
REPAIR PARTS AND SPECIAL TOOLS LIST
Section I. INTRODUCTION
Code
Explanation
C-1. Scope
P2
Repair parts which are procured and
This index lists repair parts, special tools, test and
support equipment required for the performance of
combat or military essentially of the end
organizational, direct support maintenance of the heater.
item dictates that a minimum quantity be
C-2. General
available in the supply system.
This Repair Parts and Special Tools List is divided into
M
Repair parts which are not procured or
stocked, but are to be manufactured in
the following sections:
indicated maintenance levels.
A
Assemblies which are not procured or
authorized for the performance of maintenance at the
stocked as such, but are made up of two or
organizational level in figure and item number
more units. Such component units carry
sequence.
individual stock numbers and descriptions,
b. Special Tools, Test and Support Equipment-
are procured and stocked separately and
Section III. Not applicable.
can be assembled to form the required
assembly
at
indicated
maintenance
categories.
authorized for the performance of maintenance at the
X
Parts and assemblies which are not
direct support level in figure and item number sequence.
procured or stocked and the mortality of
d. Special Tools, Test and Support Equipment-
which normally is below that of the
Section V. Not applicable.
applicable end item or component. The
e. Federal Stock Number and Reference Number
failure of such part or assembly should
result in retirement of the end item from the
supply system.
ascending numerical sequence, followed by a list of
X1
Repair parts which are not procured or
reference numbers appearing in all of the listings, in
stocked. The requirement for such items
alpha-numeric sequence, cross-referenced to the
will be filled by use of the next higher
illustration figure number and item number.
assembly or component.
NOTE
X2
Repair parts which are not stocked. The
indicated maintenance category requiring
Items not illustrated are cross-referenced to
such repair parts will attempt to obtain same
assembly group number.
through cannibalization. Where such repair
parts
are
not
obtainable
through
C-3. Explanation of Columns
cannibalization, requirements will be
The following provides an explanation of columns in the
requisitioned,
with
accompanying
tabular lists in sections II through IV.
through
normal
supply
channels.
C
Repair
parts
authorized
for
local
a. Source, Maintenance, and Recoverability Codes
procurement, where such repair parts are
(SMR).
not obtainable from local procurement,
requirements will be requisitioned through
NOTE
normal supply channels accompanied by a
Common hardware items known to be
supporting statement of nonavailability from
local procurement.
readily available in Army supply channels
G
Major assemblies that are procured with
are assigned Maintenance codes only.
PEMA funds for initial issue only as
Source codes. Recoverability Codes, and
exchange assemblies at DSU and GSU
Maintenance Allowances are not assigned
level. These assemblies will not be stocked
this category.
above DS and GS level or returned to depot
supply level.
(1) Source code.
Indicates the selection
(2) Maintenance code. Indicates the lowest
status and source for the listed item. Source codes
category of maintenance authorized to install the listed
used are:
item. The maintenance codes are:
Code
Explanation
Code
Explanation
O
Organizational maintenance
P
Repair parts which are stocked in or
F
Direct support maintenance
supplied from the GSA / I)SA, or Army
(3) Recoverability code. Indicates whether
supply system and authorized for use at
unserviceable items should be returned for recovery or
indicated maintenance categories.
salvage.
Items not coded are expendable.
Recoverability codes are:
C-1