• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Chapter 1. INTRODUCTION
Figure 1-1. Multifuel Space Heater, Left Front, Three-Quarter View.
Figure 1-2. Multifiel space heater, right rear, three-quarter view.
Figure 1-3. Electrical schematic diagram (Heater Model UH-48-C)
Figure 1-3.1. Electrical schematic diagram (Heater Model UH-48-C)
Figure 1-4. Electrical schematic diagram (Heater Model UH-48-D)
Figure 1-4.1. Electrical schematic diagram (Heater Model UH-48-D)
Table 1-1. Tabulated Data
Section I. OPERATING PROCEDURES
Figure 2-1. Heater Controls and connectors
Figure 2-2. Room thermostat.
Operation Under Rainy or Humid Conditions
Section II. PREVENTIVE MAINTENANCE CHECKS AND SERVICES
Table 3-2. Operator/Crew Troubleshooting
Chapter 4. ORGANIZATIONAL MAINTENANCE INSTRUCTIONS
Figure 4-2. Base plan.
Section II. MOVEMENT TO NEW WORKSITE
Table 4-1. Organizational Preventive Maintenance Checks and Services
Table 4-2. Organizational Maintenance Troubleshooting
Table 4-2. Organizational Maintenance Troubleshooting - Continued
Figure 4-3. Primary radio interference suppression components.
Cover Panels and Case.
Figure 4-4. Heater housing assembly, exploded view.
Figure 4-5. Control panel, exploded view.
Figure 4-6. Fuel flow diagram.
Figure 4-7. Side view heater showing internal components.
Figure 4-8. Top view of heater showing internal components.
Figure 4-9. Fuel strainer, exploded view.
Figure 4-10. Fuel system, exploded view.
Figure 4-11. Fuel pump filter, exploded view.
Carburetor and Solenoid Valve.
Figure 4-12. Carburetor and solenoid valve, exploded view.
Section IX. MAINTENANCE OF ELECTRICAL SYSTEM
Thermocouple
Figure 4-13. Burner head components, exploded view.
Figure 4-14. Motor brush installation.
Section X. MAINTENANCE OF BURNER ASSEMBLY
Chapter 5. DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE INSTRUCTIONS
Table 6-1. Direct Support and General Support Troubleshooting -- Continued
Chapter 6. REPAIR OF CONTROL PANEL
Removal and Disassembly.
Cleaning and Inspection.
Chapter 7. REPAIR OF ELECTRICAL CONTROL COMPONENTS
Figure 7-1. Electrical control components exploded view.
Cleaning and Inspection.
Chapter 8. REPAIR OF IGNITION POWER SUPPLY
Figure 8-1. Ignition power supply installation, exploded view.
Cleaning and Inspection.
Figure 8-2. Ignition power supply wiring diagram.
Figure 9-1. Carburetor installation exploded view
Figure 9-2. Burner head component, exploded view.
Figure 9-3. Burner head, heat exchanger, and blower installation, exploded view.
Cleaning and Inspection.
Chapter 10. REPAIR OF BLOWER ASSEMBLY
Figure 10-2. Burner head components, exploded view.
Figure 10-3. Burner head, heat exchanger and blower installation, exploded view
Figure 10-4. Blower assembly, exploded view.
Cleaning and Inspection.
Reassembly and Installation.
REFERENCES
MAINTENANCE ALLOCATION CHART
Section II. MAINTENANCE ALLOCATION CHART
Section III. TOOL AND TEST EQUIPMENT REQUIREMENTS






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.