TM 5-4520-253-13
lNSPECT/REMOVE/lNSTALL POWER RECEPTACLE AND EXTERNAL FUEL PUMP
RECEPTACLE (CONT)
5.
6.
7.
6.
Install POWER RECEPTACLE (4) in mounting hole from inside heater case. Secure receptacle using four
screws (1), lock washers (2), and nuts (3). Attach terminal end of ground wire (7) to one screw/lock
washer/nut combination during this step.
Install louver panel (11) by locking eight studs (12).
Reach through heater case opening (10) and connect louver linkage to louver.
Install bottom cover (9) using six screws (7) and lock washers (8).
3-64
Change 2