5-3. CABIN.ET ASSEMBLY AND SKID MAINTENANCE - Continued.
Cleaning solvent, Federal Specification P-D-680, is toxic and flammable. Use only in a well-
ventilated area. Avoid prolonged breathing of fumes. Keep solvent away from flames. Do not
use in excessive amounts. Avoid skin contact.
Clean cabinet and skid with cleaning solvent (item 11,,Appendix E) and a medium bristle brush (item 2,
Appendix E) to remove all traces of soot and dirt. Clean fuel level gage hole area on fuel tank.
Allow to dry.
Inspect cabinet and skid for corrosion, cracks and dents.
Inspect duct covers for cracks.
Inspect all fasteners for deformed threads.
Remove lifting eyes (11).
Install stacking screw (1) from side hole and screw into top hole.
Install duct cover assemblies (1), lockwasher (3), flat washer (2), and screw (4).
Apply a small amount of silastic adhesive around the fuel level gage hole area on fuel tank. Place
cabinet (8) into position on skid (9).
Install thirty-one flat washers (7), thirty-one lockwashers (6), and thirty-one screws (5).
Install heat exchanger (para 5-4c).
Install blower, pump, and motor assembly (para 4-6h).
Install duct covers (para 3-12e).
Install lower access door (para 2-6c).
(10) Install fuel level gage (para 3-41d).
(11) Install combustion air hose (para 3-40d).
(12) Install fuel nozzle (para 3-39d).