Figure 5-3.6. Burner Chamber
Remove Top Shell (ref. 5.1.2)
Remove Bottom Shell (ref. 5.1.3)
Remove Vent Fan Assembly (ref. 5.2.1)
Remove Combustor Assembly (ref. 5.3.1)
Using a 3/4" deep socket or 3/4" wrench, remove Igniter Holder from the Burner Housing
Using a #2 cross-tip screwdriver, remove three (3) screws holding the Burner Chamber to the Burner Housing.
Do NOT allow Burner Wick to fall from Burner Cartridge
Remove the burner Cartridge from inside the Burner Chamber
Do NOT use any metallic objects to clean the Push Nut or the Fuel Shaft.
Compressed air jets and/or cleaning spray (carburetor cleaner) is permitted. The
use of a rifle bore cleaning brush is permitted. Gently wiping with a soft cloth is
permitted. See Fig. 5-3.7.