BURNER FAN PLATE ASSEMBLY
Figure 5-5.7. Burner Fan Plate Assembly
Remove vehicle power cable from MS Power connector.
Remove Top Cover (ref. 5.1.1)
Remove Logic Wiring Harness connectors from the Fuel Pressure Sensor (J4) (ref. 5.5.1), and the Diagnostic
Display (J2) (ref. 5.5.2).
Remove Power Wiring Harness connectors from the Fuel Injector (J5), (ref. 5.5.5) and the Burner Fan Driver
Board (J3) (ref. 5.5.6).
Note: All the connectors in the Top Housing are different in size and shape. All
connectors have locking tabs, which can be released by finger pressure.
Remove the two (2) fuel lines from the Burner Fan Plate fuel fittings.
Remove Fuel Pump (ref. 5.5.3)
Using a #1 cross-tip screwdriver, unscrew the two (2) screws which hold the MS Power connector (J2) to the
Note screw sizes and locations for reassembly;