TM 9-4520-251-14
5-20 Axle (CONT)
Location/Item
Action
Remarks
Do not work under raised vehicle held by only one support. Be sure
each support alone can hold vehicle.
2. Trailer
Tilt trailer (4) up on rear edge at approximately
45° angle, Support trailer in this position with
jack stand or other strong support.
3. Grease cups
Pry off grease cups (5).
4. Hubs and
Remove cotter pins (6) and discard. Remove
wheels
castellated nuts (7), and pull hubs (8) and wheels
(9) off axle (10).
NOTE
Lubricate wheel bearings with lubricant grease (Appendix E, Item 3) as de-
scribed in paragraph 410.
5.
Axle
Remove screws (11) and washers (12), and lift
off axle (10).
1. Screw
2. Washer
3. Backtow
4. Trailer
5. Grease cup
6. Cotter pin
7. Castellated nut
8. Hub
9. Wheel
10. Axle
11. Screw
12. Washer
5-49