TM 9-4520-251-14
Table 4-2. Unit Maintenance Troubleshooting - Continued
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
4. HEATER WILL NOT IGNITE
Step 1.
Step 2.
Check ignition assembly (1), high tension cable (2), and ignition wire assembly (3) for good
connections. Test ignition assembly components. (See paragraph 447.)
Repair or replace ignition assembly if defective.
Inspect connector kit (1) at the end of high tension cable (2) for burned spring (3) or other de-
fects.
Replace connector kit. (See paragraph 4-48.)
NOTE
If high tension cable is damaged, replace ignition assembly as a unit.
4-26