T M 9 - 4 9 3 1 - 3 8 1 - 1 4 & P - 2
F R A M E 2 3
Remove Connector:
NOTE
Read paragraph 2-4 on tagging and crimping wires before
doing any work.
1.
Unscrew and takeout two screws (1) from connector (2) with screwdriver.
2. Pull connector (2) off of receptacle connector J1 (3).
3. Using extract tool, remove wires (4) from connector (2). Look at contacts (5), if bad
replace contacts (5). Turn in connector (2).
InstalI Connector:
4. Using insert tool, install wires (4) in new connector (2); refer to wiring chart,
frame 24.
5.
Position connector (2) on connector J1 (3) and tighten two screws (1) with
screwdriver.
GO TO FRAME 24
2-248
Volume IV
Para. 2-9, Task 12