T M 9 - 4 9 3 1 - 3 8 1 - 1 4 & P - 2
F R A M E 2
Remove Plate:
NOTE
Use this task to remove either of two stationary plates (1).
Only one stationary plate (1) is shown.
1.
Unscrew and take out four machine screws (2) with screwdriver. Set screws (2)
aside for later use.
2. Take stationary plate (1) off of riser assembly (3). Look at stationary plate (1) for
cracks or breaks. If bad, turn in. If OK, set aside for later use.
Follow-on Maintenance:
NOTE: To install stationary plate, refer to task 10.
TASK 2 ENDS HERE
Volume IV
4-8
P a r a . 4 - 5 , T a s k2