LO 5-3895-278-12
NOTES:
1.
FOR OPERATION OF EQUIPMENT IN
PROTRACTED COLD TEMPERATURES BELOW -15F
(-26C). Remove lubricants prescribed in Key for
temperatures above -15F (-26C). Relubricate with
lubricants specified in Key for temperatures below -15 F
(-26C).
If OEA lubricant is required to meet the
temperature ranges prescribed in the Key, OEA lubricant
is to be used in place of OE/HDO-10 lubricant for all
temperature ranges where OE/HDO-10 is specified in
the Key.
2. OIL CAN POINTS. Each 50 hours, lubricate yoke
pins, pivot pins, door hinges and fasteners, control
linkages, and all exposed adjusting threads with
OE/HDO.
3. WHEEL BEARINGS. Each 1000 hours, remove
wheels, clean and inspect all parts, replace damaged or
worn parts, repack bearings, and assemble.
4. ENGINE. To service, refer to LO 5-2805-203-14.
Copy of this Lubrication Order will remain with the
5. LUBRICANTS. The following is a list of lubricants
equipment at all times, instructions contained herein are
with military symbols and applicable specification
mandatory.
numbers.
By order of the Secretary of the Army:
OE/HDO
MIL-L-2104
GAA
MIL-G-10924
JOHN A. WICKHAM, JR.
OEA
MIL-L-46167
General, United States Army
BFS
MIL-B-46176
Chief of Staff
(SD) , Type II
P-D-680
OFFICIAL:
ROBERT M. JOYCE
Major General, United States Army
The Adjutant General
DISTRIBUTION:
To be distributed in accordance with DA Form 12-25B,
Operator and Organizational maintenance requirements
for Bituminous Heaters.
TA 220615
IU.S. GOVERNMENT PRINTING OFFICE: 1984-420-903/239
CARD 3 OF 3
