TM 10-4500-200-13
Section III. SPECIAL TOOL AND SPECIAL TEST EQUIPMENT REQUIREMENTS
Maintenance
Reference
Tool Number
Nomenclature
Category
Code
5120-293-0809
Wrench, open end, fixed, double head type, 3/8 inch and
C
1-C
9/16 in. wrench openings 22o, 5-1/8 inch long.
5120-293-2123
Wrench, open end, fixed, thin double head type, 1/4 inch and
C
2-C
7/16 inch wrench openings, 22o angle, 4-3/8 inch long.
5120-595-9193
Wrench, pipe V jaw style w/screwdriver on one end 7/8 inch
C
3-C
maximum IPS opening 5 inches long.
Section IV. REMARKS
Reference
Remarks
Code
HEATERS, SMALL TENT (M1941) (TYPE I & II)
Inspect door for alignment.
A-A
B-A*
Inspect for leaks and damage to adapter.
C-A*
Inspect vent tube for looseness and damage to tube and threads.
D-A*
Inspect hose for breaks and deterioration.
D-C*
Tighten hose connections.
Inspect hoses in burner pot for obstructions.
E-A
Keep small hoses in burner pot free from carbon, soot and rust by cleaning with matchstick or wooden peg.
E-C
Clean grates.
F-C
G-A*
Inspect float valve to see that it is securely mounted and properly connected and for damaged controls.
Inspect for holes and clogged pipes.
H-A
Clean soot and carbon from pipes.
H-C
I-A*
Inspect for holes and clogged cap.
I-C*
Clean soot and carbon from cap.
Inspect flue damper for operability.
J-A
Clean soot and carbon from flue damper.
J-C
Inspect for holes and clogged arrestor.
K-A
Clean soot from arrestor.
K-C
Inspect for worn or frayed lines.
LA
HEATER, SMALL TENT M1950 (YUKON)
Inspect door for alignment.
A-A
Inspect for leaks and damage to adapter.
B-A*
C-A*
Inspect vent tube for looseness and damage to tube and threads.
Inspect hose for breaks and deterioriation.
D-A*
E-C*
Clean carbon deposit from burner body.
F-A*
Inspect valve for leaks.
Inspect for holes and clogged condition.
G-A
Clean soot and carbon from pipes.
G-C
Inspect cap for holes and clogged condition.
H-A
Clean flue cap.
H-C
Inspect for worn or frayed lines.
LA
HEATERS, IMMERSION
A-A*
Inspect for dents or open seams, holes or broken welds.
A-C*
Clean dust, grease, and scale from immersion heater body.
B-A*
Inspect draft gate for cracks and immersion.
F-A*
Inspect immersion burner for evidence of cracks and distortion.
F-C*
Clean immersion burner, evaporator plate.
G-C*
Clean any obstructions from fuel valve.
H-A*
Inspect burner hood for damage or distorted hinge.
Inspect lighter cup for evidence of distortion.
I-A
J-A*
Inspect wick for deterioriation.
K-A*
Inspect wick retainer for loose fit.
L-C*
Clean soot from pipe sections.
*APPLICABLE TO LIQUID FUEL ONLY
Change 14
C-3/(C-4 blank)
