TM 10-4520-259-13&P
b. Remove sight assembly cap (1).
c. Remove smoke box cover (2) and smoke box cover gasket (3) by removing eight nuts (4) and eight washers (5).
d. Remove water heater handle (6) by removing four nuts (7), eight screws (8), and four washers (9). Lift handle
up.
e. Remove drain cock (10) from water vessel (11).
f. Remove water vessel (11) from skid (12) by removing seven nuts (13), seven washers (14) and seven screws
(15).
g. Remove fuel line holder (16) by removing two screws (17).
REPAIR
a. Make needed repairs or replace vessel or skid as necessary.
b. Weld the following components made of steel in accordance with MIL-W-52574 Type I:
Water vessel
Drum fill adapter extension
Blower duct
Handle
Burner tube
Flue support
Filter mounting bracket
Fuel line holder
Transformer mounting plate
Smoke pipe elbow assembly
Control box and cover
Smoke pipe cap and guard
c. Weld the skid assembly, made of aluminum, in accordance with MIL-W45206 Class B.
d. After welding, clean all exposed metal surfaces using cleaning compound. Then apply a coat of primer (Item 12,
Appendix F) and a finish coat of enamel paint (Item 11, Appendix F).
INSTALL
a. Install fuel line holder (16) and secure with two screws (17).
b. Attach water vessel (11) to skid (12) using seven screws (15), seven washers (14) and seven nuts (13).
Change 2
5-27
