SECTION III
REPAIR PARTS SUPPLY
3-1. General.
a. .The basic policies and procedures in AR 710-2, AR 725-50 and DA Circular 700-27 are generally applicable to
repair parts management for construction equipment.
b. Manufacturer's parts manuals are furnished with the heater instead of Department of the Army Repair Parts
and Special Tool List (RPSTL).
c. National Stock Number (NSNs) are initially assigned only to PLL/ASL parts and major assemblies, i.e., engines,
transmissions, etc. Additional NSNs are assigned by the supply support activities as demands warrant.
d. Automated Processing (AUTODIN) of Federal Supply Code Manufacturer (FSCM) part number requisitions,
without edit for matching NSNs and exception data, is authorized.
e. Proper use of assigned project codes on part number requisitions are essential.
f. Repair parts are available from commercial sources and may be purchased locally in accordance with AR 710-
2, AR 734-110 and DA Circular 700-27.
g. Initial Prescribed Load List (PLL) and Authorized Stock List (ASL) will be distributed by US Army Tank-
Automotive Command (TACCM) , ATTN: DRSTA-FH.
3-2. Prescribed Load List (PLL).The PLL distributed by TACOM is an estimated 15 days supply recommended for initial
stockage at organizational maintenance. Management of PLL items will be governed by the provisions of AR710-2
and local command procedures. Selection of PLL parts for shipment to CONUS/OCONUS units is based upon the
receiving Command's recommendation after their review of the TACOM prepared list. Organizations and activities in
CONUS/OCONUS. will establish PLL stocks through normal requisitioning process.
3-3. Authorized Stockage List (ASL).The ASL distributed by TACOM is an estimated 45 days supply of repair parts for
support units and activities. The ASL parts will be shipped according to the recommendations of the receiving
Commands, after they have reviewed the initial list distributed by TACOM. Support units and activities in CONUS/
OCONUS will establish ASL stocks through requisitioning process.
5