TM 5-4520-256-14
Section III. SERVICE UPON RECEIPT OF EQUIPMENT
Para.
Service Upon Receipt of Materiel.............................. 3-5
3-5. SERVICE UPON RECEIPT OF MATERIEL.
a.
Unpacking Equipment. (Refer to Figure 3-1).
WARNING
Steel banding, cut under tension, can snap free and cause injury. Leather gloves and face shield
are required.
CAUTION
Be careful when unpacking heater to avoid damage to equipment. Do not slide one heater unit
across the top of another. Lift it off if stacked vertically. Do not stand or sit on top of heater
unit. Failure to comply may result in damage to equipment.
NOTE
The wooden shipping skid and vinyl protective sheet are used when shipped to first destination.
Thereafter, use of the skid and vinyl cover are optional.
(1)
Cut metal bands (2) and remove vinyl cover (3).
(2)
If heater units are received in the stacked configuration, remove four stacking bolts (4) and remove top heater
unit. Repeat until bottom unit is reached.
(3)
Remove four bolts securing heater unit to shipping skid (5).
(4)
Remove any tape or protective material from exterior surfaces of heater unit(s).
(5)
Remove heater air ducts from shipping containers (1). Save containers for reuse.
3-2
