TM 9-2540-206-24&P
BURNER PLATE - HUPP MF510B, MF510C, MF60A-24V, MF60B-24V
This task covers:
a. Removal
c. Installation
b. Inspection/Cleaning
INITIAL SETUP
Tools
Personnel Required
Tool Kit, Mechanics Gen (Item 1, Appendix B)
63G
Materials/Parts
Equipment Condition
Rags, wiping (Item 5, Appendix C)
Burner thermostat/preheater
Solvent, drycleaning (Item 8, Appendix C)
removed (page 3-58)
Igniter removed (page 2-35
LOCATION
ITEM
ACTION
REMARKS
REMOVAL
1. Burner plate (1)
Nut assembly (2)
Unscrew and remove,
2. Inlet tube (3)
Nut (4)
Loosen.
3. Combustion chamber (5)
Burner plate (1)
Remove.
4. Burner plate (1)
Grommet (6)
Remove.
INSPECTION/CLEANING
NOTE
For more instructions on how to inspect and clean parts, go to General Maintenance
Instructions (page 2-l).
5.
Drycleanlng solvent PD-680 Is both toxic and flammable. Wear protective
goggles and gloves, and use only In well-ventilated area. Avoid contact with
skin, eyes, and clothes, and don’t breathe vapors. Do not use near open flame
or excessive heat. The flashpolnt Is 100°F to 138°F (38°C to 59°C). If you
become dizzy while using drycleaning solvent, get fresh air immediately, and
get medlcal aid. If contact with eyes is made, wash your eyes with water, and
get medlcal ald immediately.
Burner plate (1)
a. Soak in solvent to loosen
carbon.
b. Wipe dry with clean, dry rags.
c. Look for cracks, breaks,
burned through areas, and
signs of fuel leakage around
fuel inlet tube.
Replace plate if damage
Is found.
3-60
WARNING
