TM 9-4520-258-14
CHAPTER 2
OPERATING INSTRUCTIONS
PAGE
Section I.
Description and Use of Operator's Controls and Indicators ...............................................
2-1
2-1.
Introduction......................................................................................................................
2-1
2-2.
Location and Use of Controls and Indicators ....................................................................
2-2
Section II.
Operator's Preventive Maintenance Checks and Services (PMCS) ..................................
2-5
2-3.
General ...........................................................................................................................
2-5
2-4.
PMCS Procedures ..........................................................................................................
2-5
2-5.
Cleaning Agents...............................................................................................................
2-7
2-6.
Leakage Definitions for Operator PMCS ..........................................................................
2-7
Section III.
Operation Under Usual Conditions ...................................................................................
2-21
2-7.
Assembly and Preparation for Use ..................................................................................
2-21
2-8.
Operating Procedures ......................................................................................................
2-25
2-9.
Decals and Instruction Plates ...........................................................................................
2-32
Section IV.
Operation Under Unusual Conditions ..............................................................................
2-39
2-10. Unusual Environment/Weather .......................................................................................
2-39
2-11. Emergency Procedures ...................................................................................................
2-40
2-12 Nuclear, Biological, and Chemical (NBC) Decontamination Procedures ..........................
2-41
Section I. DESCRIPTION AND USE OF
OPERATOR'S CONTROLS AND INDICATORS
2-1.
INTRODUCTION.
This section describes the controls and indicators the operator will use most often. The following paragraphs are brief
descriptions of each control and indicator.
2-1
