TM 9-4520-272-14&P
0057 00
SERVICE continued
3. Once the battery terminal connector has been removed from the battery terminal post (3), clean the
battery terminal connector (1) and battery terminal post with a wire brush.
4. Install the battery terminal connector (1) on the battery terminal post (3) and secure the nut (2).
REPLACE
1. To replace a damaged terminal connector (1), remove the connector from the battery terminal post
(3) as described in the SERVICE section above.
2. Cut the damaged connector from the battery cable (5). If the cable is damaged, replace the cable
first.
3. Strip approximately 1/2 inch of insulation (6) from the end of the battery cable.
4. Loosen the bolt (7) securing the terminal connector clamp (8) and insert the stripped portion of the
battery cable into the clamp.
5. Tighten the bolt (7) to firmly secure the battery cable (5) in the clamp (8).
6. Install the terminal connector (1) onto the battery terminal post (3) and secure with the nut (2).
END OF WORK PACKAGE
0057 00-2
