TM 9-4520-272-14&P
0061 00
REPLACE continued
4. Disconnect the operator control box cable assembly (6) from the connector (7) located at the lower
right corner of the main control box (8).
5. Install a new operator control box cable assembly (6) by connecting one of the cable connectors (9)
to the main control box connector (7). Tighten securely.
6. Slip clamps (5) over the cable and secure to the two locations in the heater with screws (3) and lock
washers (4). Tighten securely.
7. Slide the remaining cable connector (2) through the hole (10) near the operator control box (11).
8. Secure the operator control box cable assembly connector (1) to the operator control box connector
(2).
2
1
6
4
5
3
6
3
5
4
6
0061 00-3
