TM 9-4520-272-14&P
0074 00
INSTALLATION
1. Install fuel tappet (11) into engine crankcase.
2. Install shim(s) (10) onto injection pump studs (7 and 8).
3. Install injection pump (3) onto upper studs (8), aligning tooth (12) on control lever with slot on
governor lever (13). Governor lever must be set so slot is in the center of opening in housing. Install
nuts (9) and tighten to 7.2 to 8.7 ft-lbs. (100 to 120 kg-cm).
4. Install gasket (6), cover (5), and nut (4) on lower stud (7). Tighten to 7.2 to 8.7 ft-lbs. (100 to 120 kg-
cm).
3
11
10
12
8
8
8
7
13
3
5
8
7
9
6
4
0074 00-4
