TM
9-4940-660-14&P
c.
With the control switch in the OFF position, insert the
power cable plug into the 110-120 volt electrical supply.
If a t h r e e p r o n g r e c e p t a c l e i s n o t a v a i l a b l e o n t h e
NOTE :
electrical supply, procure and use a mating two
prong outlet adapter with a grounding lead.
SECTION
II
I
OPERATING
INSTRUCTION
S
Operating
Controls
6.
The three position toggle switch controls
a.
Control Switch.
the thermal gun as follows:
in the COOL (center) position
the blower motor is energized but the heater element is
unenergized, resulting in a flow of cool ambient air from
the nozzle; in the HEAT (up) position both the blower motor
and heater element are energized, and in the OFF (down)
position both the blower motor and heater element are un-
energized resulting in shutdown.
b.
Adjustable Intake Cover.
This side vent can be
positioned
to control the air temperature flowing from the
gun nozzle.
The cover is qraduated in degrees Fahrenheit so
that when
with the arrowhead on the cover,
air with
it is alined
that approximate temperature will be discharged
from the
nozzle.
Operating Procedure
7.
a.
With the control switch
OFF
set
the
gun
operation
as
described in para 5.
Place the switch to COOL. The motor should run smoothly
b.
and the blower should force ambient air from the nozzle.
c.
Rotate
adjustable
intake
cover
to
the
desired
heat
range.
d.
Place control switch to HEAT and
allow about 60
seconds
for warm-up and stabilization of
temperature.
not touch the nozzle or place anything but
WARNING :
DO
the product to be worked on directly in front
of it.
3
