4-76. POWER INLET REPLACEMENT (CONT)
Power inlet can be replaced with panel down. If you close panel during power inlet replacement, ensure
door is closed and one or more clamps are in place. Failure to comply will create an unsafe condition and
may result in injury to personnel.
Tag and mark all wires prior to removal.
Note position of outlet prior to removal.
(4) Loosen two screws (9) and remove interior (10) from body (11).
(5) Loosen eight screws (12) and remove four wires (13) from interior (10).
(6) Remove four nuts (14), screws (15), body (11), and gasket (16) from control box (17). Discard gasket.
(1) Install gasket (16) and body (11) with four screws (15) and nuts (14) in control box (17) and tighten nuts.