TM 9-4520-271-14
UNIT MAINTENANCE INSTRUCTIONS
ARMY SPACE HEATER H-140
NSN 4520-01-477-0568
POWER CABLE ADAPTER
REPAIR
INITIAL SETUP:
References
Test Equipment
None
None
Materials/Parts
Tools and Special Tools
Solder (item 23, WP 0061 00)
Automotive general mechanic's tool kit
Wire marker tag (item 25, WP 0061 00)
(item 10, WP 0058 00)
Wire tie (item 24, WP 0061 00)
Electrical repair shop set (item 8, WP 0058 00)
Soldering iron (item 8, WP 0058 00)
Equipment Condition
Personnel Required
ASH disconnected from power source
One
REPAIR
1.
Repair of power cable adapter consists of replacing defective parts.
2.
If cable is damaged, replace cable as follows:
a. Cut strap (1) from connector plug (2) and remove cover (3).
b. Remove two nuts (4), screws (5), and saddles (6).
c. Unscrew clamp (7) and slide clamp, grommet follower (8), grommet (9), and rubber bushing (10) down onto cable
(11).
d. Unscrew sleeve (12) from connector plug (2) and slide down onto cable (11).
e. Tag three wires (13) and cut connector plug (2) from cable (11).
f. Cut wire tie (14) from cable (11).
g. Slide sleeve (12), rubber bushing (10), grommet (9), grommet follower (8), and clamp (7) from cable (11).
h. Slide clamp (7), grommet follower (8), grommet (9), rubber bushing (10), and sleeve (12) onto cable (11).
0040 00-1
