TM 9-4520-271-14
0053 00
ASSEMBLY
Continued
3.
Install fuel tube (17) into baffle (18) until baffle contacts hex nut on fuel tube.
4.
Secure fuel tube (17) to baffle (18) with setscrew (16).
5.
Install two sleeves (10) into block (15) 0.10 to 0.16 inch (0.25 to 0.41 cm) from outer surface of block. Ensure that slots
are 180 degrees (3200 mils) away from two setscrews (7).
6.
Install two electrodes (8), O-rings (9) (item 38, WP 0062 00) to aline baffle (18), and block (15).
NOTE
Distance between the front of the block and the back of the baffle is 1.19 to 1.25 inches (3.02 to 3.17 cm).
7.
Install fuel tube (17) through center hole in front of block (15).
8.
Secure fuel tube (17) into block (15) with setscrew (14). Torque setscrew to 10 to 15 lb-in. (1.1 to 1.6 Nm).
9.
Remove two electrodes (8) and O-rings (9).
0053 00-4