TM 9-4931-381-14&P-2
FRAME 3
Remove Card Assembly:
CAUTION
Touching card assembly components can damage
components. Hold card assemblies by edges at all times.
Do not flex or twist card assembly.
NOTE
Use this task to take out any of ten circuit card
assemblies. Card assembly A2 (1) is shown.
If removing more than one circuit card assembly, tag
each card assembly and wrap with clean rag.
1.
Pull out on ejectors (2) of circuit card assembly (1) to release card assembly (1).
2. Pull card (1) out of digital subsystem assembly (3).
3. Look at card assembly (1) for cracks. If bad, turn in. If OK, set aside for later use.
Follow-on Maintenance:
NOTE: To install circuit card assembly A2, A3, A4, A5, A6, A7, A9, A10, A13, or
A14, refer to task 19.
TASK 3 ENDS HERE
Volume IV
Para. 2-7, Task 3
2 - 1 22