TM 10-4520-259-13&P
4-23. DRUM FILL ADAPTER ASSEMBLY, TYPE II.
This task covers:
a.
Disassembly
b.
Inspect
c.
Assembly
INITIAL SETUP:
Tools:
Tool Set, General (Item 1, Appendix B)
Materials/Parts:
Rag, Wiping (Item 15, Appendix F)
Sealer (Item 13, Appendix F)
Equipment Condition:
Adapter assembly not in use.
DISASSEMBLY
a.
Remove extension adapter (1) from pipe connector (2) by turning counterclockwise.
b.
Remove pipe connector (2) from pipe (8).
c.
Remove two male connectors (3) by turning counterclockwise and remove caps (4) or fuel lines from connectors.
d.
Remove two screws (5), four washers (6), block (7) and adapter pipe (8).
e.
Remove adapter pipe (8) from block (7) by turning counterclockwise.
f.
Remove cover (9) from nipple (10) by turning counterclockwise.
Change 2 4-54
