TM 10-4520-261-12&P
SPACE HEATER ARCTIC (SHA)
0019 00
UNIT MAINTENANCE
0019 00-1
FUEL FLOW CONTROL VALVE CUP/CABLE ASSEMBLY
THIS SECTION COVERS:
Service and Replace
INITIAL SETUP
SHA shut-down and cool (WP 0005)
Maintenance Level
Unit
Tools and Special Tools
Materials/Parts
General Mechanic Tool Kit (WP 0025, Table 2, Item 1)
Rope, wire (WP 0046, Table 1, Item 8)
Swaging Tool (WP 0025, Table 1, Item 3)
Sleeve, swaging (WP 0046, Table 1, Item 9)
Wire Cutters (WP 0025, Table 1, Item 2)
REPLACE
Cut unserviceable wire rope (1) from priming cup (2) and from fuel flow control valve bracket (3).
Cut 16 inch (40.6 centimeter) section of serviceable wire rope (1) from bulk wire rope supply.
Thread approximately 1 ½ inches (3.81 centimeters) of one end of wire rope (1)through a swaging sleeve
(4).
Thread the same end of the wire rope (1) through the priming cup (2) perforation, and then back through
the swaging sleeve (4) (a 3/4 inch [1.91 centimeter] loop should be formed).
Crimp the swaging sleeve (4) down on the wire ropes (1) so that the loop is permanently closed.
Thread approximately 1 ½ inches (3.81 centimeters) of the opposite end of wire rope (1) through the
other swaging sleeve (4).
Thread this same end of wire rope (1) through the fuel flow control valve bracket (3) perforation, and then
back through the swaging sleeve (4) (a 3/4 inch [1.91 centimeter] loop should be formed).
