TM 10-4520-261-12&P
SPACE HEATER ARCTIC (SHA)
0005 00
OPERATION UNDER USUAL CONDITIONS
0005 00-21
PREPARATION FOR MOVEMENT AFTER LIQUID FUEL OPERATION
DISASSEMBLING THE STACK ASSEMBLY
WARNING!
Hot Surfaces
Do not disassemble a hot heater. Allow the heater to cool completely
before handling or moving. Handling a hot heater may result in severe
burns.
On the outside of the shelter, untie the stack cap assembly guy lines (1) from their ground stakes (2).
Remove ground stakes (2) and stow.
On the inside of the shelter, lift the exhaust stack assembly (3) with stack cap assembly (4) and attached
lines (1) from stack adaptor opening (5). Lower the stack assembly through the exhaust opening (6), and
set on piece of wood to prevent gouging of shelter floor. Remove the lower sections of the stack
assembly (3) and lower the remainder of the stack assembly until the stack cap (4) with attached lines (1)
is positioned near the exhaust opening closure (6). On the outside of the shelter, have a second person
remove the stack cap assembly (4) with attached guy lines (1) from the top section of the stack assembly.
Lower the remainder of the stack assembly through the exhaust opening closure (6). Close and secure
the exhaust opening closure (6).
Disassemble and nest the stack assembly (7). Set stack cap (4) with attached guy lines (1) aside.
1
2
3
4
5
6
7
