TM 10-4520-262-12&P 0020 00
0020 00-6
14. To install a new solenoid valve and sediment strainer assembly (1), insert the sediment strainer
outlet fitting (9) into the rubber grommet (20) on the sediment strainer bracket (19) closest the fuel
hose (13). Continue until the solenoid valve inlet fitting (18) has cleared the external fuel system
bracket (17).
15. Swing the left end of the assembly with the solenoid valve inlet fitting (18) under the external fuel
system bracket (17) and insert the fuel solenoid inlet fitting (18) into the hole on the external fuel
system bracket (17).
16. Rotate the assembly (1) while sliding the assembly to the left until the holes on the top of the fuel
solenoid valve (16) are aligned with the holes on the external fuel system bracket (17).
17. Install the two screws (15) and protective dust cap (10) through the external fuel system bracket
(17) and into the fuel solenoid valve (16). Tighten securely.
18. Wrap a rag around the end of the fuel hose (13) and grasp the end of the fuel hose near the fuel
hose fitting (14) with a pair of pliers. Be sure that the rag is between the hose and the pliers in
order to protect the hose from damage.
19. While holding the fuel hose (13) securely, use a wrench to engage the fuel hose fitting (14) on the
sediment strainer outlet fitting (9). Make sure that the fittings (9 and 14) engage correctly and do
not cross-thread. Tighten the fuel hose fitting (14) securely.
20. Clean any residual thread sealant from the threads of the fuel quick disconnect elbow fitting (12)
that was removed and set aside earlier. Apply new thread sealant to the threads of the fuel
solenoid inlet fitting (18). Tighten the fuel quick disconnect elbow fitting (12) securely taking care
to align the opening (22) on the elbow fitting (12) so that it faces outward.
21. Clean any residual thread sealant from threads of the fuel quick disconnect (11).
22. Apply new thread sealant to the threads of the fuel quick disconnect (11).
23. Install the fuel quick disconnect (11) into the fuel quick disconnect elbow fitting (12) and tighten
securely.
24. Reconnect the fuel solenoid valve electrical connectors (8). Install the wire loom (21) over the fuel
solenoid wires and connectors (8). Install a new tie wrap (7) over the wire loom (21) and bracket
(19) to secure the wire loom to the sediment strainer outlet fitting (9).
