TM 5-3895-377-13&P
Table 4-2. Unit Troubleshooting - CONT.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
CHASSIS ELECTRICAL (CONT)
2.
TURN SIGNALS DO NOT OPERATE (CONT).
Step 5. Remove screws and cover from junction box. Using a multimeter, check for continuity across terminal on
circuit breaker marked YEL (for left turn signal) and/or GRN (for right turn signal)
If continuity is present, replace or repair wiring between junction box and junction block.
If continuity is not present, replace circuit breaker (page 4-97).
Step 6. Using a multimeter, check for continuity across pins marked YEL (for left turn signal) and/or GRN (for right
turn signal) and jumpers to the circuit breakers marked YEL (left) and/or GRN (right).
If continuity is not present, replace 12 Vdc intervehicular connector (page 4-97).
If continuity is present, replace or repair wire between 12 Vdc intervehicular connector and resistor.
4-32
