TM 5-3895-377-13&P
Table 4-2. Unit Troubleshooting - CONT.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
CHASSIS ELECTRICAL (CONT)
1.
TAILLIGHTS DO NOT OPERATE (CONT).
Step 7.
Remove screws, lock washers, cover, and gasket from junction box. Remove wire from resistors.
Using multimeter, check resistance across resistor.
If 4 ohms + 1 or 5 ohms f 1 are not measured, replace resistor (page 4-65).
Step 8.
Using a multimeter, check continuity between pin E on 24 Vdc intervehicular connector receptacle
and resistor.
If continuity is not present, replace 24 Vdc intervehicular connector (page 4-93).
If continuity is present, replace or repair wire between receptacle and resistor.
4-29
