TM 5-3895-377-13&P
c. Adjustment.
NOTE
You will hear a thump and shaft will stop
turning when float touches bottom.
(1)
Using lock jawed pliers, turn shaft (3) clockwise
until float (6) touches bottom of expansion tank
(7). Hold shaft in this position while performing
step (2).
(2)
With the aid of an assistant, and while holding
shaft position point of indicator (2) at the
"EMPTY’ mark on the decal (8) tighten setscrew
(1) and release shaft (3).
(3)
Move indicator (2) until point is at the "LOW
LIMIT" mark on the decal (8). Hold indicator in
this position while performing step (4).
(4)
Turn
cam
(5)
counterclockwise
until
lobe
depresses roller (9) and engages low oil sensor
switch (10).
(5)
Tighten setscrew (4) and release indicator (2).
(6)
Check adjustment by turning indicator (2) until
float (6) touches bottom of expansion tank (7).
(7)
Move indicator (2) up 8° and check that cam (5)
has engaged low oil sensor switch (10) and point
of indicator (2) is on "LOW LIMIT" mark on the
decal (8).
(8)
Repeat steps (1) through (7) if conditions do not
exist.
NOTE
Follow-on Maintenance: Remove wheel
chocks (page 2-35).
END OF TASK
4-195
