TM 5-3895-377-13&P
Section I. REPAIR PARTS; SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT; AND
SUPPORT EQUIPMENT
5-1. COMMON TOOLS AND EQUIPMENT.
a.
For authorized common tools and equipment refer to the Modified Table of Organization and Equipment
(MTOE), CTA 50-970 or CTA 8-100, as applicable to your unit.
b.
The basic tool kit is: Tool Kit, General Mechanic’s SC 5180-90-CL-N05.
5-2. SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT.
Refer to Appendix B, Section III, of the Maintenance Allocation Chart (MAC) for a list of tool kits authorized for the Heater.
Refer to Appendix G, Repair Parts and Special Tools List (RPSTL), for a list of special tools required for maintenance of
the Heater.
5-3. REPAIR PARTS.
Repair parts are listed and illustrated in Appendix G of this manual.
Section II. SERVICE UPON RECEIPT
5-4. PACKING AND UNPACKING.
Upon receipt of a new Heater, the receiving organization must see if it has been properly prepared for service and is in
good condition. Inspect all assemblies, subassemblies, and accessories to be sure that they are in proper working order.
Secure, clean, and correctly adjust and/or lubricate as needed (Chapters 2 and 3). Check all tools and equipment
(Appendix C and Appendix D) to be sure every item is there in good condition, clean, and properly stowed.
Section III. PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS), LUBRICATION INSTRUCTIONS, AND
MANDATORY REPLACEMENT PARTS
5-5. LUBRICATION INTRODUCTION.
Lubrication instructions are part of the PMCS. All lubrication instructions are mandatory.
5-2
