TM 5-4520-244-14
APPENDIX B
COMPONENTS OF END ITEM LIST
Section I INTRODUCTION
(2) Item Number. The number used to
B-1.
Scope.
identify item called out in the illustration.
National Stock Number (NSN). Indicates
b.
This appendix lists Integral Components of
and Basic Issue Items (BID) for the Heater to
the national stock number assigned to the end
help you inventory items required for safe and
item which will be used for requisitioning.
efficient operation.
Part Number (P/N). Indicates
c.
the pri-
B-2 .
General.
mary number used by the manufacturer which
controls the design and characteristics of
The components of end item list are divided
the item by means of its engineering drawings,
into the following sections:
specifications, standards and inspection re-
quirements to identify an item or range of
a.Section II.
Integral Components of the
items .
End Item. These items, when assembled, com-
d. Description.
prise the heater and must accompany it when-
Indicates the federal
item name and, if required, a minimum descrip
ever it is transferred or turned in. These
illustrations will help you identify these
tion to identify the item.
items.
Location. The physical location of
e..
b. Section III.
Basic Issue Items. These
each item listed is given in this column,
are minimum essential item's required to place
The lists are designed to inventory all items
the heater in operation, to operate it and to
in one area of the major item before moving on
perform emergency repairs. Although shipped
to an adjacent area.
separately packed, they must accompany the
f. Usable on Code.
heater during operation and whenever it is
"Usable On" codes are
transferred between accountable officers.
included to help you identify which component
The illustrations will assist you with hard-
Iden-
items are used on the different models.
to-identify items. This manual is your author-
tification of the cldes used in this list are:
ity to requisition replacement BII based on
Table(s) of Organization and Equipment (TOE)/
Used On
Code
Modification Table of Organization and Equip-
ment (MTOE) authorization of the end item.
Model FC-400-1
B-3.
Explanation of Columns.
g. Quanity Required (Qty Reqd). This
column lists the quantity of each item required
for a complete major item.
a.
Illustration.
This column is divided
as follows:
This column is left blank for
h. Q u a n t i t y .
(1) Figure Number. Indicates the fig-
use during inventory. Under the received col-
umn, list the quantity you actually receive on
ure number Of the illustration on which the
your major item. The date columns are for use
item is shown (if applicable).
when you inventory the major item at a later
date, such as for shipment to another site.
B-1
