TM 5-4520-253-13
REMOVE/lNSTALL/TEST/REPAIR
IGNITION
TRANSFORMER
AND
CABLE
(CONT)
8. Pry grommet (26) out of hole (27) in exchanger housing bottom panel (28). Pull ignition cable
(10) out through hole.
9. Remove four nuts (21), lock washers (22), and flat washers (23). Lift transformer (24) off
bulkhead (25).
INSTALLATION:
1.
2.
3.
4.
5.
6.
Install transformer (24) on bulkhead (25) using four flat washers (23), lock washers {22), and
nuts (21 ).
Connect yellow and white transformer wires (16 and 17) to quick disconnect terminals (18) on
yellow and white PC board assembly wires (19 and 20). Connect yellow wire to yellow wire and
white wire to white wire.
Install ignition cable (10) through
hole (27) in exchanger housing
bottom (28),
Connect ignition cable (10)
to igniter (11).
Press grommet (26) into
hole (27).
Install cable clamp (12)
using screw (13), lock
washer (14), and nut (15).
3-112
