TM 5-4520-256-14
3-30.
HIGH TENSION CABLE ASSEMBLY MAINTENANCE - Continued.
d. Repair.
(1) Use a sharp knife to cut off sleeving (2).
(2) Slide 90 boot (3) back from terminal (4).
(3) Unsolder terminals (4) then remove 90° boot (3). Repeat for other end for straight boot (6) and terminal (5).
(4) Replace parts as required.
(5) If using a new cable, strip insulation back 1/4 inch.
(6) Slide heat shrink sleeving (2) over cable (1).
(7) Slide 90 boot (3) over cable (1).
(8) Solder terminal (4) to conductor. Repeat for other end for straight boot (6) and terminal (5).
(9) Slide 90° boot (3) over terminal (4) to expose cable insulation. Then apply a thin film of silastic adhesive
(item 1, Appendix E) to end of insulation. Repeat for other end.
(10) Slide 90° boot (3) back over insulation. Repeat for other end.
(11) Slide sleeving (2) over 90°boot (3) and apply heat to shrink sleeving.
3-92
