TM 9-2540-205-24&PTROUBLESHOOTING-CONTINUEDSTEWART- WARNER 10560C24, 10560M, 10560M24B1, 10560G - CONTINUEDMALFUNCTIONTEST OR INSPECTIONCORRECTIVE ACTION1. HEATER DOES NOT START-ContinuedStep 6. Check blower motor (3) as follows:a.b.c.d.e.Remove blower assembly (10560C24and 10560G, page 3-99; 10560M and10560M24B1, page 3-105).Remove motor subassembly (10560M and 10560M24B1 only,page 3-1 05).Take out two screws (4) holding semiconductor device/diode mounting as-sembly (5) to case of blower assembly (6) (10560C24 and 10560G).Disconnect motor lead (7) from semiconductor device diode mounting as-sembly output terminal (8).Place red multimeter probe on motor lead (7) and black probe on case ofblower motor (3).1. If multimeter reading is greater than 0.5 ohms, replace blower motor(10560C24 and 10560G, page 3-99; 10560M and 10560M24B1, page3-105).2. If multimeter reading is less than 0.5 ohms, go on to step 7. Do not rein-stall blower assembly or motor subassembly at this time.3-13
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
