TM 9-2540-205-24&P
FUEL REGULATOR VALVE - STEWART-WARNER 10560C24, 10560M - Continued
LOCATION
ITEM
ACTION
REMARKS
ASSEMBLY - Continued
65. Valve body (1)
Gasket (2)
Install.
66.
Plunger assembly (3), spring (4), a. Put together.
and core assembly (5)
b. Install and hold.
67.
Case (6)
a. install.
b. Let go of core assembly (5),
and hold case (6).
68. Case (6) and valve body (1)
Three screws (7)
a. Screw in and tighten.
b, Let go of case (6)
NOTE
Do not perform steps 69 and 70 unless cover or coil were replaced.
69. Lead (8) and coil (9)
70. Lead (8)
71. Case (6)
72. Cover (6)
INSTALLATION
73. Heater (14)
74. Fuel regulator valve (15)
and heater (14)
75. Overheat switch (17)
76. Terminal strip (19)
77, Fuel regulator valve (15)
Cover (10)
Terminal (11 )
Cork washer (12), coil (9),
and cover (1 O)
Screw assembly (13)
Fuel regulator valve (15)
Three screw assemblies (16)
Lead (8) and nut assembly (18)
Restriction solenoid lead (20)
and screw assembly (21 )
Two new tie wraps (22)
Install.
a. Strip approximately 3/16-inch
insulation off lead (8).
b. Place terminal (11) in position,
and crimp.
Install.
a. Screw in and tighten.
b. Repeat steps 66 thru 72a for
other side.
Install.
Screw in and tighten.
Screw in and tighten.
Screw in and tighten.
Install, and cut off excess.
3-82
