DIODE MOUNTING ASSEMBLY - STEWART-WARNER 10560M, 10560M24B1 Continued
LOCATION
ITEM
ACTION
REMARKS
REMOVAL - Continued
6. Voltage Iimiter assembly (1)
and diode mounting
assembly (2)
7. Voltage limiter assembly (1)
8. Grommet (5)
9. Diode mounting
assembly (2)
10.
11. Air housing (11)
INSTALLATION
12. Air housing (11)
13. Diode mounting
assembly (2)
14.
15. Voltage limiter assembly (1)
16. Grommet (5)
17. Diode mounting
assembly (2) and voltage
limiter assembly (1)
18. Blower housing (12)
and motor (13)
19. Air housing (11) and
motor (13)
20.
Two tie wraps (3)
Lead (4)
Lead (6)
Screw assembly (7)
and lead (8)
Two screw assemblies (9)
and lead (8)
Diode mounting assembly (2)
Diode mounting assembly (2)
Two screw assemblies (9)
and lead (10)
Lead (8) and screw
assembly (7)
Lead (4)
Lead (6)
Two new tie wraps (3)
Air housing (11)
Four screw assemblies (14)
Ventilation blower wheel (15)
a. Cutoff.
b. Discard.
Remove.
Pull through.
a. Unscrew and remove.
b. Pull wire lead (8) out through
diode mounting assembly (2).
Unscrew and remove.
Remove.
Install.
Screw in and tighten.
a. Push wire lead (8) through
diode mounting assembly (2).
b. Screw in and tighten.
Install.
Push through.
Install, and cut off excess.
Push in, and line up holes in air
housing (11 ) with holes in motor
(13).
Screw in and tighten.
Slide on with setscrew (4) in line
with flat side of shaft.
3-123
TM 9-2540-205-24&P
