TM 9-2540-205-24&P
VOLTAGE REGULATOR ASSEMBLY - STEWART-WARNER 10560M, 10560M24B1 - Continued
LOCATION
ITEM
ACTION
REMARKS
INSTALLATION
10.
11.
12.
13.
14.
15.
16.
17.
18.
Air housing (2)
Voltage regulator
assembly (1) and air
housing (2)
Voltage regulator
assembly (1)
Voltage regulator
assembly (1) and
two leads (4)
Blower housing (6) and
motor (7)
Air housing (2) and
motor (7)
Blower housing (6) and
ventilation blower
wheel (9)
Blower housing (6)
Voltage regulator assembly (1)
Screw (3)
Two leads (4)
New tie wrap (5)
Air housing (2)
Four screw assemblies (8) ,
Ventilation blower wheel (9)
Setscrew (10)
Plug (11)
Install.
Screw in and tighten.
Install.
Install, and cut off excess.
Push in, and line up holes in air
housing (2) with holes in motor (7).
Screw in and tighten.
Slide on with setscrew (10) in
line with flat side of shaft,
a. Rotate wheel (9) so set-
screw (10) is in line with hole
in housing (6).
b. Tighten.
Install.
3-118
