BURNER ASSEMBLY - STEWART-WARNER 10560M, 10560M24B1 - Continued
LOCATION
ITEM
ACTION
REMARKS
INSTALLATION
9. Heat exchanger (1)
10. Burner (2)
11. Heater housing (4)
12. Burner (2) to fuel
controll/metering valve (6)
13. Fuel tube (7)
14. Burner (2)
15. Igniter tube (9)
16. Burner (2)
17. Bracket (11)
18. Cap (13)
19. Adapter (15)
20. Cap (13)
Burner (2)
Four screws (3)
Seal (5)
Fuel tube (7)
Two nuts (8)
Igniter tube (9)
Screw assembly (10)
Bracket (11)
Two screws (12)
New preformed packing (14)
Cap (13)
Screw assembly (16)
and washer (17)
Install.
Screw in and tighten into two
top and two bottom holes.
Install.
a. Install.
b. Push until firmly seated.
Screw in and tighten.
Install.
Screw in and tighten.
Install.
New brackets do not
have wide flange, older
brackets do. Either can
be used. Wide part of
older bracket must go
toward air Inlet tube.
Screw in and tighten.
Install.
Install.
Screw in and tighten.
3-129
TM 9-2540-205-24&P
