TM 9-2540-205-24&P
BURNER REPAIR - STEWART-WARNER 10560C24, 10560M, 10560M24B1, 10560G - Continued
LOCATION
ITEM
ACTION
REMARKS
CLEANING/INSPECTION
7. Plate (1)
Cup (2) and shield (3)
a. Clean with wire brush.
b. Inspect for damage.
Replace entire burner
If either part Is cracked,
warped, or burned
through.
8.
Plate (1)
a. Clean with wire brush.
b. Clear out all vent holes.
c. Remove any wick particles
left in igniter pocket.
d. Inspector damage.
Replace entire burner if
plate is cracked,
warped,or burned
through.
9. Plate (1)
10.
11.
12. Wick and vaporizer
assembly (6)
13. Plate (1)
Two new slotted washers (4)
New retaining washer (5)
New wick and vaporizer
assembly (6)
Two new washers (8),
shield (3), and screw (9)
Cup (2), three screws (10),
and nuts (11)
Position as shown.
a. Install.
b. Press into place.
a. Install.
b. Using thin wire wrapped
around wick, pull wick into
igniter pocket.
c. Take thin wire off wick.
d. Hook wick onto support in
igniter pocket (7).
e. Pull wick through vaporizer
until it is drawn uptight.
f. Cutoff excess.
a. Install.
b. Screw in and tighten.
a. Install.
b, Screw in and tighten.
3-133
ASSEMBLY
