TM9-2540-205-24&P
IGNITION SPARK GENERATOR - ESPAR V7S
This task covers:
a. Removal
b. installation
INITIAL SETUP
Tools
Personnel Required
Tool Kit, Mechanics Gen (Item 1, Appendix B)
63G
Materials/Parts
Equipment Condition
Sealant, silicon (Item 6, Appendix C)
Hood removed (page 3-135)
Tags, marking (Item 9, Appendix C)
LOCATION
ITEM
ACTION
REMARKS
REMOVAL
NOTE
Tag all wires and terminals to aid during installation (page 2-3).
1. Glow plug (1)
2. Fixed wire resistor (3)
3. Terminal board (5)
4. Ignition spark generator (7)
5. Clamp (10)
6. Heater (12)
7. Lead (13)
8. Socket (2)
INSTALLATION
9. Socket (2)
10. Lead (13)
11. Heater (12)
12. Clamp (10)
13. Ignition spark generator (7)
3-136
Socket (2)
Lead (4)
Lead (6)
Two screws (8) and washers (9)
Screw (11)
Ignition spark generator (7)
Socket (2)
Terminal (14)
Terminal (14)
Socket (2)
Ignition spark generator (7)
Screw (11) and ignition
spark generator (7)
Two screws (8) and washers (9)
Remove.
a. Cutoff sealant.
b. Remove.
a. Cut off sealant.
b. Remove.
Unscrew and remove.
Unscrew and remove.
Remove.
Unscrew and remove.
Remove.
Install.
Screw in.
a. Make sure ground lug (15) is
around mounting hole.
b, Install.
a. Put generator (7) on wire
harness clamp (10).
b. Tighten screw (11).
Screw in and tighten.
