IGNITOR - STEWART-WARNER 10560C24, 10560M, 10560M24B1, 10560G - Continued
LOCATION
ITEM
ACTION
REMARKS
INSTALLATION
7. Heater (1)
8. lgniton control (3)
9. Ground terminal (5)
Igniter (2)
Lead (4)
Lead (6)
a. Push in so wires are near fuel
tube.
b. Turn clockwise until it stops.
c. Release.
d. Tug slightly on igniter leads
and release to seat igniter.
Install.
lnstall.
WARNING
Stewart-Warner heaters must not be operated without rubber gaskets cover-
ing the igniter. Failure to install this gasket could cause deadly carbon mon-
oxide gas to enter the vehicle and result In personnel Injury or death.
10.
Rubber gasket (7)
a. Install around leads (4) and(6)
and fuel tube (8).
b. Push down.
11. Rubber gasket (7)
Electrical inlet assembly (9)
Install.
12. Electrical inlet assembly (9)
Two fasteners (10)
Turn one-quarter turn clockwise.
2-51
TM 9-2540-205-24&P
