TM 9-2540-205-24&P
OVERHEAT SWITCH - STEWART-WARNER 10560C24, 10560M, 10560M24B1, 10560G
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Tools
Equipment Condition
Tool Kit, Mechanics Gen (Item 1, Appendix B)
Guard removed (page 2-42)
LOCATION
ITEM
ACTION
REMARKS
NOTE
Tag all wires and terminals to aid during installation (page 2-3).
1. Overheat switch (1)
Two nut assemblies (2)
Unscrew and remove.
2.
Two leads (3)
Remove.
3.
Two screw assemblies (4)
Unscrew and remove.
4. Heater (5)
Overheat switch (1)
Remove.
INSTALLATION
The overheat switch doss not control heater temperature. It is a factory-ad-
justed safety device. Any attempt to adjust thls switch may result in injury to
5. Heater (5)
Overheat switch (1)
Install.
Terminal marked “g”
goes toward ignition
control (6).
Two screw assemblies (4)
Screw in and tighten.
Two leads (3)
Slip onto terminals as marked on
leads.
6. Overheat switch (1)
7.
8.
Two nut assemblies (2)
Screw on and tighten.
2-53
W A R N I N G
personnel.
R E M O V AL
