TM 9-4520-258-14
4-35. FUEL TANK ASSEMBLY.
This task consists of:
a. Removal
b. Disassembly
c. Repair
d. Assembly
e. Installation
INITIAL SETUP:
Tools:
General Safety Requirements:
Tool Kit, General Mechanics (Item 1, App B)
WARNING
Drain Pan (Item 2, App B)
Fuels are toxic and flammable. Do not get on person
Material/Parts:
or clothing. Do not use near open flame. Area
Lockwasher (Item 1, App H)
should be well ventilated.
Lockwasher (Item 8, App H)
Lockwasher (Item 10, App H)
Fuels Flammable / No Smoking.
Sealant (Item 6, App E)
Contact with hot components can cause burns.
Preformed Packing (Item 28, App H)
Allow unit to cool down before attempting
service/inspection/maintenance activity.
Equipment Condition:
Unit disconnected from power source (para 2-8)
Rear panel removed (para 4-20)
NOTE
Disassemble only to the level required to make repairs.
a.
Removal (Refer to Figure 4-67)
WARNING
Fuel is flammable and toxic to eyes, skin, and
respiratory tract. Skin/eye protection required. Avoid
repeated/prolonged contact. Use only in well ventilated
areas. Keep away from open flames or other sources of
ignition. No SMOKING around the area. Suitable fire
extinguisher must be present.
Fuels are toxic and flammable. Do not get on person or
clothing. Do not use near open flame. Area should be
well ventilated.
(1)
Extend jack assembly (1), remove pin (2) and place wheel assembly (3) in the down
position. Insert pin (2).
(2)
Retract jack assembly (1) until front of Unit (4) is resting on the ground.
(3)
Remove four screws (5) four lockwashers (6), four flat washers (7), fuel drain cover (8) and
gasket (9). Discard lockwashers and gasket.
4-166
