TM 9-4520-272-14&P
0083 00
8
7
5
INSTALL
1. If removed, install bearings (4, 6).
2. Carefully insert assembled balancer shaft (5) and gear (7) into cylinder block (8). Align match-marks
(9) on balancer gear and crankshaft gear, then press balancer shaft (5) into bearing (6).
3. Apply grease to lips of crankshaft oil seal (located in crankcase cover (1)).
4. Apply oil to crankshaft and camshaft. Make sure that oil pump drive gears are properly engaged.
5. Mate cover gasket (3) to cylinder block (8).
6. Mate crankcase cover (1) to cylinder block (8) and secure using fifteen screws (2). Tighten screws in
criss-cross sequence as shown. Torque all screws to 14.5 to 16.6 ft-lbs. (200 to 230 kg-cm).
7. Service engine oil (WP 0046 00).
0083 00-3
